Ariens 924124-ST926DLE User's Manual | Page 26

Ariens Snow Blower User's Manual - 924124-ST926DLE.
Download
Page  of 32
4.9, 1073 votes
background image

GB - 26

8. Remove attachment drive belt from 

attachment pulley (hold brake away from 
belt).

Install new attachment drive belt:

1. Place new attachment belt onto 

attachment pulley.

2. Tip housing and frame back together and 

secure with cap screws.

3. Place belt onto engine sheave.
4. Make sure engine sheave and attachment 

pulley align. If alignment is necessary, 
loosen attachment pulley set screws, 
reposition pulley and retighten set 
screws.

5. Reposition and secure belt fingers.

IMPORTANT: Make sure belt fingers are 
1/16 in. to 1/8 in. (1.6-3mm) from belt when 
attachment clutch is engaged.

6. Check adjustment. See Attachment 

Clutch/Brake.

7. Reconnect chute crank and secure with 

spring clip. If equipped, reconnect remote 
cap deflector cable and/or electric chute 
wire harness.

8. Replace belt cover.

TRACTION DRIVE BELT 
REPLACEMENT
NOTE: 
Housing and frame must be tipped 
apart and attachment drive belt removed from 
engine sheave in order to change traction 
drive belt. 

1. Remove attachment drive belt (see 

Attachment Drive Belt Replacement).

2. Pull idler away from traction drive belt and 

remove belt from idler pulley, engine 
sheave and driven pulley (it may be 
necessary to turn engine pulley using 
recoil handle).

NOTE: To gain clearance, engage traction 
clutch and if necessary pull back attachment 
idler arm clevis pin.

3. Install new traction drive belt onto 

attachment pulley and engine sheaves.

4. Replace attachment drive belt (See 

Replace Attachment Drive Belt).

FRICTION DISC REPLACEMENT

1. Place unit into service position.

2. Remove bottom cover by removing four 

cap screws.

3. Place speed selector in first (1) position 

and depress traction clutch lever to hold 
friction disc and hub in position.

4. Remove cap screws from hub 

(Figure 25).

Figure 24

1. Traction Belt Idler
2. Cap Screw
3. Belt Finger
4. Traction Drive Belt
5. Attachment Belt 

Idler

6. Attachment Drive 

Belt

7. Engine Sheave
8. Attachment Pulley
9. Attachment Idler 

Adjustment Nut

OS3320

1

2

3

4

5

6

7

8

9

WARNING: AUGER / IMPELLER 
MUST STOP within 5 seconds when 
attachment clutch lever is released or 
unit damage or serious injury may 
result.

Related Manuals for Ariens 924124-ST926DLE

0.558731s