GE 24927v2 GE Universal Remote Owner's Manual | Page 8

GE Remote Control Owner's Manual - 24927v2 GE Universal Remote.
Download
Page  of 42
4.5, 1161 votes
background image

8

  Programming Your Remote, cont.

Auto Code Search

The Auto Code Search searches automatically 
through all of the codes stored in this remote. Read 
all the following steps prior to starting the auto 
search as you will need to be prepared to lock-in the 
proper code when found. 

1.  Manually turn on the device you wish 

to control.

2.  Press and hold the 

SETUP button 

until the red indicator light stays on 
(approximately 4 seconds) and then 
release the button. 

3.  Press and release the desired device 

button on the remote (

TV, DVD, CBL, 

SAT, DVR, AUX, AUDIO, VCR). The red 
indicator will blink once and then 
remain on. 

4.  Point the remote at the device and 

press and release the 

POWER button 

(for TV) or 

PLAY button (for DVD, VCR, 

etc.) to start the search. The red 
indicator will flash (approximately 
every 2 seconds) as the remote 
searches. 

Note: The remote must be 

pointed at the device for the duration 
of this search. 

5.  Place your finger on the 

#1 button so 

you are prepared to lock-in the code.

6.  When the device shuts off or begins 

playing, press the 

#1 button to lock-in 

the code.  The red indicator light will 
turn off. 

Note:  You have approximately 

two seconds after the device shuts off 
or begins playing to lock-in the code.
 

7.  Point the remote at the device and 

check to see if the remote operates 
the device as desired. If it does, no 
further programming is required for 
that device. If it does not, return to 
step 2 and start the auto search again. 

Related Manuals for GE 24927v2 GE Universal Remote

0.474648s