Carvin B400 Quick Reference Guide

Carvin Audio Quick Reference Guide - B400.
Download
Page  of 1
4.8, 2199 votes
background image

The B400 Battery Kit is for replacing a worn battery in a S400/S400D StageMate™ or use as a second battery to

extend battery time.  The B400 Battery Kit comes with the following:  1 B400 12V Battery, a set of color coded battery
connection wires and an L-bracket and screw.  If any of the following items are missing from your Kit please contact
our Customer Service Dept. Mon. - Fri. at 800-854-2235.

ADD A SECOND BATTERY TO DOUBLE YOUR BATTERY TIME

To double your battery time, you may order the optional B400 battery.  This is recommended for high levels and longer operation

time when adding the 810 extension speaker.

1. To add the second battery, remove the 4 screws from the StageMates™ rear chassis and carefully remove the chassis from the
cabinet. FIG 1

2. Observe the empty slot on the right bottom side of the cabinet and place the battery into position and install the L bracket that
comes with the B400 kit to hold the battery in place.

3. The original battery on the left has spare terminals for connecting the second battery.  Simply connect the supplied B400 battery
wires to the negative and positive terminals on the original battery.   Always match negative (-) to negative and positive (+) to positive.
Black is used for negative (-) and red for positive (+).  Never allow a negative wire or terminal to touch a positive wire or terminal or
“sparks will fly” with possible damage to the battery.  If in doubt, please call our service department Mon. - Fri. at 800-854-2235.

REPLACING THE BATTERY

After a few years of use, if you notice your operation time has been greatly reduced, you will need to replace the battery as the

cells may have weakened with age.  The B400 battery kit is shipped with connecting wires for use as a second battery.  If you are
replacing your old battery, discard these wires as you will not need them.

A) To replace your battery, remove the 4 screws from the SoundMates™ rear chassis and carefully remove the chassis from the
cabinet. FIG 1

B) Locate the battery mounted on the left side of the cabinet FIG 2 and remove the L bracket. Simply pull the wires from the positive
and negative battery terminals on the old battery and reconnect your new battery (B400).  Be sure to match negative (-) to negative
and positive (+) to positive. Black is used for negative (-) and red for positive (+).  Be sure not to short the battery terminals with a
screwdriver or “sparks will fly” with possible damage to the battery.

FIG 2 Cutaway view

- +

- +

black

red

black

red

black

red

- +

- +

black

red

black

red

black

red

FIG 1 Cutaway view

To order accessories for your StageMate™ call

800-854-2235

or visit our online catalog

second battery

L bracket

L bracket

battery connection
wires (shipped with
B400 kit)

CARVIN ENGINEERING DATA

B400 Battery Kit for StageMate™ S400/S400D Installation Instructions

0.473204s