Epson 1400 User's Manual
INSTALLATION INSTRUCTIONS FOR
EPSON PHOTO 1400
New systems do not have the donor Epson cartridge on top of the CIS cartridges as
shown in the photos
[A] -
Set your printer to change cartridges.
[B] -
When the cartridges are parked ready to change pull out the power lead for the printer.
You will now be able to move the cartridge carriage by hand.
[C] -
Remove the cartridges and remove the cartridge carriage cover either by cutting
through the right hand hinge pin with a hot craft knife blade or by following our attached in-
structions photos 5 to 8 for removing the cover so it can be refitted at a later date.
[D] -
Move the cartridge carriage to the far left of the printer, then insert the CIS cartridges
in the large right hand hole of the printer, move them to the right and under the cross bar
and take them out of the right hand smaller hole.
[E] -
Move the cartridge carriage back under the smaller hole and fit the CIS cartridges into
the carriage.
[F] -
When fitting the CIS cartridges make sure then are well pushed down over the area of
the chips and that the 6 clear locking tabs are all clicked into position.
[G] -
Fit the tubing clips and cross bar as shown. Make sure the clips are locked closed.
[H] -
Adjust the tubing length between the cartridge carriage and the centre clip so give the
same mount of slack as shown. Move the carriage by hand over to the far left and far right of
the printer to ensure the tubing runs freely and there is just enough slack to allow free move-
ment.
[I] -
You can now reconnect the power lead and switch the printer on.
[J] -
If you get a red light after fitting then set the printer to change cartridges and when
they are parked in the change position press the small white manual reset button as shown in
photo 9, hold this in for few seconds and then release. Cartridges should now be recognised,
if not you do not have the cartridges locked in correctly.
[K] -
Having installed the CIS cartridges you should now stand the ink tanks on the same
level as the printer and fit the 6 clear air filters as shown in photo 4.
TROUBLE SHOOTING TIPS
[L] -
You MUST place the ink tanks on the same level as the printer, higher or lower will re-
sult in ink starvation or ink flooding.
[M] -
When you get an ink out light the chip on the cartridge is set back to full by setting the
printer to change cartridges and when parked in the change position you need to push in the
manual reset button as shown in photo. Hold this in for a few seconds and then release. The
cartridge chip should now be reset to full.
[N] -
We STRONGLY recommend that you stand the ink tanks in a small container!!!
Related Manuals for Epson 1400
-
Brother Photo Printer DCP-135C User's Manual
98 pages
-
Canon Photo Printer CP-220 User's Manual
64 pages
-
Canon Photo Printer iP1800 Series User's Manual
72 pages
-
Canon Photo Printer IP3500 User's Manual
88 pages
-
Canon Photo Printer Photo Printer iP4800 User's Manual
468 pages
-
Canon Photo Printer PIXMA iP4300 User's Manual
102 pages
-
Canon Photo Printer PIXMA iP5000 User's Manual
100 pages
-
Canon Photo Printer PIXMA iP6700D User's Manual
2 pages
-
Canon Photo Printer PIXMA MG6120 User's Manual
13 pages
-
Canon Photo Printer PIXMA PRO9000 User's Manual
2 pages
-
Canon Photo Printer SELPHY CP400 User's Manual
97 pages
-
Canon Photo Printer SELPHY CP510 User's Manual
69 pages
-
Epson Photo Printer STYLUS DX6000 User's Manual
36 pages
-
Epson Photo Printer Stylus Photo R280 User's Manual
32 pages
-
Epson Photo Printer Stylus Photo RX650 User's Manual
2 pages
-
Ricoh Photo Printer AFICIO MP C300 User's Manual
8 pages
-
Ricoh Photo Printer Aficio MP C4000 User's Manual
8 pages
-
Ricoh Photo Printer Aficio MP C5000 User's Manual
8 pages
-
Samsung Photo Printer SPP 2040 User's Manual
81 pages
-
Sony Photo Printer UP-D897 User's Manual
22 pages
-
Kodak Photo Printer 400 II User's Manual
2 pages
-
Durst Photo Printer Theta 76 User's Manual
10 pages
-
Durst Photo Printer Theta 76 HS User's Manual
10 pages
-
HP Photo Printer PHOTOSMART 7550 User's Manual
64 pages