Garmin vivofit, Red, With Heart Rate Monitor Owner's Manual | Page 4

Garmin Activity Tracking Owner's Manual - vivofit, Red, With Heart Rate Monitor.
Download
Page  of 6
4.4, 2193 votes
background image

Replaceable coin cell batteries may contain perchlorate 

material. Special handling may apply. See www.dtsc.ca.gov

/hazardouswaste/perchlorate.

 CAUTION

Contact your local waste disposal department to properly 

recycle the batteries.

Replacing the vívofit Device Batteries
Before you can replace the device batteries, you must obtain 

two CR1632 batteries.
Remove the module from the band.

Use a small Phillips screwdriver to remove the four screws on 

the front of the module.

Remove the cover and batteries.

Insert the new batteries.

NOTE: Do not damage or lose the gasket.

Replace the front cover and the four screws.
Tighten the four screws equally and firmly.
Insert the module into the band.

The device key on the module must be aligned with the key 

on the band.

Replacing the Heart Rate Monitor Battery
Locate the circular battery cover on the back of the heart rate 

monitor.

Use a coin to twist the cover counter-clockwise until it is 

loose enough to remove (the arrow points to OPEN).

Remove the cover and the battery.
Wait 30 seconds.
Insert the new battery with the positive side facing up.

NOTE: Do not damage or lose the O-ring gasket.

Use a coin to twist the cover clockwise back into place (the 

arrow points to CLOSE).

After you replace the heart rate monitor battery, you may need 

to pair the heart rate monitor with the device again.

Device Care

NOTICE

Avoid extreme shock and harsh treatment, because it can 

degrade the life of the product.
Avoid pressing the keys under water.
Do not use a sharp object to clean the device.
Avoid chemical cleaners, solvents, and insect repellents that can 

damage plastic components and finishes.
Thoroughly rinse the device with fresh water after exposure to 

chlorine, salt water, sunscreen, cosmetics, alcohol, or other 

harsh chemicals. Prolonged exposure to these substances can 

damage the case.
Do not store the device where prolonged exposure to extreme 

temperatures can occur, because it can cause permanent 

damage.

Cleaning the Device
Wipe the device using a cloth dampened with a mild 

detergent solution.

Wipe it dry.
Caring for the Heart Rate Monitor

NOTICE

A build up of sweat and salt on the strap can decrease the ability 

of the heart rate monitor to report accurate data.

• Rinse the strap after every use.
• Hand wash the strap occasionally, using a tiny amount of 

mild detergent, such as dishwashing liquid.
NOTE: Using too much detergent may damage the strap.

• Do not put the strap in a dryer.
• When drying the strap, hang it up or lay it flat.

Troubleshooting
My device won't turn on
If your device no longer turns on, you may need to replace the 

batteries.

Go to Replacing the vívofit Device Batteries.

I don't have a computer or mobile device
You can turn on the device and use it with limited functionality, 

until you complete the setup process on a computer or mobile 

device. Prior to setup, you can use only the step count, auto 

goal, move bar, and heart rate monitor (if packaged with your 

device). Your device resets your step count once a day. The 

4

vívofit Owner's Manual

0.596687s