GIGABYTE GA-P55-USB3 (rev. 2.0) Owner's Manual

GIGABYTE Motherboards Owner's Manual - GA-P55-USB3 (rev. 2.0).
Download
Page  of 1
4.6, 1265 votes
background image

With GIGABYTE eXtreme Hard Drive (X.H.D)(Note 1), users can quickly configure a RAID-

ready system for RAID 0 when a new SATA drive is added. For a RAID 0 array that al-

ready exists, users also can use X.H.D to easily add a hard drive into the array to expand 

its capacity. All with a simple click of a button, X.H.D helps to enhance your hard drive 

read/write performance without the need for complex and time-consuming configurations. The following procedure 

details the steps to set up a RAID-ready system and configure it for RAID 0. 

B. Using GIGABYTE eXtreme Hard Drive (X.H.D)

(Note 1)  The X.H.D utility only supports the SATA controllers integrated in the Intel Chipset. 

(Note 2)  It is recommended that before you run the X.H.D utility, back up all of your data to avoid risk of 

hardware damage or lost of data. 

(Note 3)  If you manually build a non-RAID 0 array, you'll not be able to automatically set up a RAID 0 array 

later using the Auto function. 

1. 

 To automatically set up a RAID 0 array:

 

Click Auto to automatically and quickly set up a RAID 0 array. 

2. 

 To manually set up a RAID array: (Note 3):

 

Click Manual to access the Intel Matrix Storage Console, with which you can build a RAID 0, RAID 1, or 

other supported RAID array depending on your needs and hardware components. 

3. 

 Exits the X.H.D utility: 

 

Click Cancel to exit the X.H.D utility.

Instructions:(Note 2)

Before launching X.H.D, make sure the newly added hard-

drive has equal or greater capacity than the RAID-ready 

system drive. (To add a new hard drive into a RAID 0 ar-

ray that's been created earlier, make sure the new drive is 

greater than or equal to the biggest drive in the array. )

eXtreme Hard Drive (X.H.D)

A. Setting Up a RAID-Ready System

Step 1: Configure the system BIOS

Enter the system BIOS Setup program, set eXtreme Hard Drive (X.H.D) under the Integrated Peripherals 

menu to Enabled to enable RAID for the Intel SATA controllers.   

Step 2: Install the RAID driver and operating system

The X.H.D utility supports Windows 7/Vista/XP. Before installing the operating system, you have to load the 

SATA controller driver first. Without the driver, the hard drive may not be recognized during the Windows setup 

process. (For more details, refer to Chapter 5, "Installing the SATA RAID/AHCI Driver and Operating System." )

Step 3: Install the motherboard drivers and the X.H.D utiltiy

After installing the operating system, insert the motherboard driver disk. You can click the Xpress Install All 

button to automatically install all motherboard drivers, including the X.H.D utility. Or you can go to the Applica-

tion Software screen to individually install the X.H.D utility later.

Also See for GIGABYTE GA-P55-USB3 (rev. 2.0)

0.462039s