Honeywell CTS-20 User's Manual

Honeywell Stud Sensor User's Manual - CTS-20.
Download
Page  of 4
4.9, 1140 votes
background image

IND.CONT.EQ.

3JHX

INSTALLATION INSTRUCTIONS

62-0245—01

Solid Core and Split Core 4-20 mA

Output Current Sensors

CTS-20; CTP-20

SAFETY

WARNING

For CTS-20 Series current sensors, ensure 
that all power sources are disconnected and 
locked out before installation as severe injury 
or death may result from electrical shock due 
to contact with high voltage wires.

CAUTION

This product is not intended to be used for life 
or safety applications.

CAUTION

This product is not intended for use in any 
hazardous or classified locations.

INSTALLATION

Make sure that all installations are in compliance with all 
national and local electrical codes. Only qualified 
individuals that are familiar with codes, standards, and 
proper safety procedures for high-voltage installations 
should attempt installation. The current sensor is a 2-
wire, 4 to 20 mA Loop Powered device that requires a 
regulated +12 to 30 Vdc external power source.

IMPORTANT

The current switch should be used on insulated 
conductors only!

The current sensors may be mounted in any position 
using the two (2) #8 x 3/4 in (19 mm) Tek screws and the 
mounting holes in the base or snapped directly on to the 
1-3/8 in. (35 mm) DIN rail (See Figures 3 and 4). Leave a 
minimum distance of 1 in. (25 mm) between the current 
sensor and any other magnetic devices such as 
contactors and transformers.

Fig. 1. Sensor placed on DIN rail

Fig. 2. Sensor removed from DIN rail

C

R

U

L

U

S

3X

M25289

3X

M25290

C

R

U

L

U

S

0.557551s