Samsung Drum Washing Machine User's Manual

Samsung Washers User's Manual - Drum Washing Machine.
Download
Page  of 14
4.7, 1634 votes
background image

useful tips for your drum washing machine

✔ 

The descriptions and images in this document may differ from your actual 
purchased product. For more information, refer to the user manual.

INSTALLING YOUR WASHING MACHINE
•  Installing your washing machine in the location which is slippery 

or uneven, will result in vibrations and noise.

•  If there is too much noise or vibration, check whether the four 

levelling adjustment legs are evenly and firmly on the floor.

•  If the washing machine is not level, lift the washing machine 

slightly and adjust the lowest of the four levelling adjustment legs.

✔ 

Before using your washing machine, you must remove the 
shipping bolts from the back of the unit.  
For more information on removing the safety devices, refer to the user manual.

LEVELLING YOUR WASHING MACHINE WITH THE LEVELLING FEET

✔ 

Refer to the descriptions appropriate to your washing machine.

1. Level your washer by turning the 

adjustable nut in and out, as shown 
in the figure.

2. When your washing machine is 

level, tighten the locking nut using 
the (-) driver.

1. Unfasten the locking 

nut by turning it to the 
left using a spanner.

2. Level your washing 

machine by turning 
the adjustable feet in 
and out as necessary 
by hand.

3. Fasten the locking 

nut by turning it to the 
right using a spanner.

CLEANING THE FILTER

Cleaning the water supply filter
✔ 

If the filter net is not installed, it may cause a water leakage and operating error. Make sure to install it.

1. Pull and remove the filter net.

2. Clean the filter.

3. Insert the filter net and fasten 

its connector firmly.

Cleaning the debris filter
✔ 

When water does not drain well or ‘5E’ blinks on the display, clean the debris filter. The product appearance 
may differ from your washing machine. (However, the cleaning descriptions are the same.)

1. Open the filter 

cover using a coin 
or a key.

4. Unscrew the 

emergency drain 
cap by turning it 
counter clockwise.

2. Unscrew the 

emergency drain 
cap and pull out the 
emergency drain 
tube to drain off the 
remaining water.

5. Clean the debris 

filter and the inside 
of the drain hose.

3. Hold the cap on 

the end of the 
emergency drain 
tube and allow all 
the water to flow 
into a bowl.

6. Replace the 

debris filter, the 
emergency drain 
cap and tube and 
then close the filter 
cover.

✔ 

If you open the debris filter when water remains inside the tub, water may flow out.

✔ 

If the debris filter is assembled incorrectly or not installed, it may cause a water leakage or operating error. 
Therefore make sure to assemble it correctly.

MAKE SURE YOU KNOW...

Adding the 
laundry

•  Adding laundry

➲ 

Press the Add laundry(Stop&Add) button and add the laundry when the Add 
laundry lamp turns on.

•  If you add the laundry during a spin cycle, it starts again with the initial set time 

regardless of the remaining time.

Washing 
bedding

•  Wash bedding using only the Bedding course.

➲ 

You can wash acrylic, mixed spinning and woolen bedding.

➲ 

When washing general clothes, the washing machine may 
not operate in the optimal status.

•  Wash only one bedding item at a time regardless of size.

➲ 

Insert bedding rolled up into a ball.  
The center of gravity is distributed evenly causing less 
vibrations and noise.

✔ 

Do not wash electric blankets or carpets.

✔ 

When spinning blankets, cotton bedding, and woolen bedding, 
too much noise and vibrations may occur and the wash cannot 
be completed as spinning is not performed.

Locking nut

Adjustable nut

Spanner

(-) Driver

Nut

Adjustable feet

Spanner

Inside

Debris 

filter

Wash 

individually.

Make sure that the leveling feet 

legs are level with the floor.

Englis

h

Germa

n

Fr

enc
h

Spanis

h

Italia
n

Portugues

e

Russia

n

0.563622s