Troy-Bilt CSV206 User's Manual | Page 10

Troy-Bilt Chipper User's Manual - CSV206.
Download
Page  of 14
4.3, 2246 votes
background image

10

SECTION 6:  MAINTAINING YOUR CHIPPER SHREDDER VACUUM

Lubrication 

Wheels: Lubricate the rear wheels with light oil 
once a season.

Nozzle Door Adjustment Levers: Lubricate each 
adjustment lever once a season with light oil.

Front Caster Wheels: Grease fittings are located 
on the front caster wheels to provide easy 
lubrication of the swivel pins.

Cleaning the Flail Screen
If the discharge area becomes clogged, remove the flail 
screen and clean area as follows:

Stop the engine and make certain the chipper 
shredder vacuum has come to a complete stop.

Disconnect spark plug wire from spark plug and 
ground against the engine.

Remove the vacuum bag and tamper plug from the 
equipment and save.

Remove the four self-tapping screws from the 
bottom of the discharge chute, and the hex bolt, flat 
washer and hex nut from the top. Remove the 
discharge chute assembly. See Figure 11.

Figure 11

Remove the two hex bolts and hex nuts which 
extend through the impeller housing. Lift the flail 
screen from inside the housing. See Figure 12.

Clean the flail screen by scraping and/or washing 
with water, and reinstall the screen.

NOTE:  Be certain to reassemble the flail screen with
the curved side down.

Reattach the discharge chute assembly with the 
hardware previously removed and attach the bag to 
the unit.

Figure 12

Servicing the Blades

NOTE: When tipping the unit, empty the fuel tank and
keep the spark plug side up.

Disconnect the spark plug wire and ground it 
against the engine.

Remove the flail screen as instructed in the 
previous section.

Remove plastic belt cover from front of the engine 
by removing the two self-tapping screws. See 
Figure 13.

Remove the access plate by removing two hex lock 
nuts. See Figure 13. 

Locate one of the chipper blades in the access  
opening by rotating the impeller assembly by hand. 
Remove the chipper blade using a 3/16” allen 
wrench and a 1/2” wrench. 

Remove other blade in the same manner to replace 
or sharpen.

Figure 13

WARNING: Before performing any 
maintenance or repairs, stop the engine, wait 
until the machine comes to a complete stop, 
disconnect the spark plug wire and ground 
against the engine to prevent unintended 
starting.

Discharge
Chute 

Hex Bolt
Flat Washer
Hex Nut

Self-Tapping
Screws

Flail Screen

Hex Bolts
Hex Nuts

Belt Cover

Self-Tapping
Screws

Access Plate

Lock Nuts

0.513359s