Troy-Bilt CSV206 User's Manual | Page 6

Troy-Bilt Chipper User's Manual - CSV206.
Download
Page  of 14
4.3, 2246 votes
background image

6

Remove the three hex nuts and bell washers from 
the weld studs beside the opening on the right side 
of the chipper-shredder vacuum. See Figure 4. 

Figure 4

Place the chipper chute over the weld studs 
keeping the slotted side towards the bottom. 
Loosely secure with the three hex nuts and bell 
washers that were removed earlier. Do not fully 
tighten the hex nuts at this point in the assembly.  
See Figure 5.

Figure 5

Align the support bracket with the holes in the right 
side of the upper and lower handles where the hex 
bolts were just removed. Push up slightly on the 
chipper chute in order to better align the holes in 
the support bracket with the holes in the handles. 

Replace the hex bolts, saddle washers and flange 
nuts to affix the support bracket to the handle 
assemblies. See Figure 5. 

Follow by tightening all hardware securely first on 
the chipper chute, then on the support bracket, 
and finally on the handle.

Attaching The Bag

Place bag under the upper handle assembly and 
slip the front opening on the bag over the discharge 
chute, making certain it is over the rim on the 
discharge chute. Follow direction of the arrows in 
Figure 6. 

Figure 6

Place the four straps on top of the bag over the 
upper handle, hooking them on the studs to secure 
in place. See Figure 6. Squeeze the clamp on the 
drawstring and pull the drawstring tight. Release 
the clamp. 

Hex Bolts & 

Saddle Washers

Flange Nuts  

Weld 

Hex Nuts &

Bell Washers 

Studs  

Flange

Nuts

Chipper

Chute

Hex Nuts &

 Bell Washers

Slot

Hex Bolts & 

Saddle Washers

Support

Bracket

Bag

Upper
Handle

Discharge 
Chute

Strap

Strap

Strap

0.474445s